中低应变率范围内花岗岩单轴压缩特性的尺寸效应研究
详细信息 本馆镜像全文    |  推荐本文 | | 获取馆网全文
摘要
利用变频动态加载岩石力学试验系统对直径为50 mm,长度分别为50,75,100,125 mm的花岗岩试样进行中低应变率范围内的加载试验。研究结果表明:(1)试样强度具有显著的应变率依赖性,随着应变率增大,压缩强度近似以乘幂关系增大。(2)静载和准动态加载条件下,岩石强度基本上随试样长度的增加而减小。(3)不同应变率加载条件下,直径为50 mm的试样,长径比不小于2时,方能取得基本稳定的试验结果。(4)峰值应变随试样尺寸的增大逐渐减小。(5)割线模量E50和线性段弹性模量Et随试样尺寸的增大而增大,且Et>E50。(6)破裂形式具有显著的应变率效应,随着应变率的增高,破碎程度加大;其尺寸效应则表现为:应变率<10-3s-1时,随着尺寸的增大,破裂形式表现为劈裂–锥形破裂–剪切破裂的过程;应变率>10-2s-1时,破裂形式则直接由锥形破裂变为剪切破裂。
The static and quasi-dynamic tests on granite specimens under various strain rates are conducted by using rock dynamic loading system.The specimens are 50 mm in diameter,with the length of 50,75,100,125 mm,respectively.The research results are drawn as follows:(1) Specimen strength is significantly dependent on strain rates and increases with the growth of strain rates with a power relationship.(2) Under static and quasi-dynamic loading conditions,rock strength generally decreases with the increase in specimen length.(3) When the diameter of specimen is 50 mm,the aspect ratio should be not smaller than 2;then steady test results can be obtained under different strain rates.(4) Peak strain under each strain rate decreases with increasing specimen size.(5) Both of secant modulus E50and elastic modulus Etincrease with increasing specimen size;and Etis larger than E50.(6) Failure mode is significantly dependent on strain rates and failure is serious when the strain rate increases.When strain rate <10-3s-1,failure mode has a process of split failure-taper failure-shear failure;when strain rate >10-2s-1,the failure mode changes from taper failure to shear failure directly.
引文
[1]洪亮,李夕兵,马春德,等.岩石动态强度及其应变率敏感性的尺寸效应研究[J].岩石力学与工程学报,2008,27(3):526–533.(HONG Liang,LI Xibing,MA Chunde,et al.Study of size effect ofrock dynamic strength and strain rate sensitivity[J].Chinese Journal ofRock Mechanics and Engineering,2008,27(3):526–533.(inChinese))
    [2]BA ANT Z P.Size effect on structural strength:a review[J].Archiveof Applied Mechanics,1999,69(9):703–725.
    [3]VAN MIER J G M,VAN VLIET M R A.Influence of microstructureof concrete on size/scale effects in tensile fracture[J].EngineeringFracture Mechanics,2003,70(16):2 281–2 306.
    [4]TANG C A,THAM L G,LEE P K K,et al.Numerical studies of theinfluence of microstructure on rock failure in uniaxial compression——part II:constraint,slenderness and size effect[J].International Journalof Rock Mechanics and Mining Sciences,2000,37(4):571–583.
    [5]尤明庆,苏承东.大理岩试样的长度对单轴压缩试验的影响[J].岩石力学与工程学报,2004,25(22):3754–3760.(YOU Mingqing,SU Chengdong.Effect of length of fine and coarse crystal marblespecimens on uniaxial compression tests[J].Chinese Journal ofRock Mechanics and Engineering,2004,25(22):3 754–3 760.(inChinese))
    [6]KIM J K,YI S T,PARK C K,et al.Size effect on compressivestrength of plain and spirally reinforced concrete cylinders[J].ACIStructural Journal,1999,96(1):88–96.
    [7]尤明庆,华安增.岩样单轴压缩的尺度效应和矿柱支承性能[J].煤炭学报,1997,22(1):39–43.(YOU Mingqing,HUAAnzeng.Thesize effect of uniaxial compression of rock specimen and supportcapacity of ore pillar[J].Journal of China Coal Society,1997,22(1):39–43.(in Chinese))
    [8]HUDSON J A,CROUCH S.Soft,stiff and servo-controlled testingmachines[J].Engineering Geology,1972,6(3):155–189.
    [9]王学滨,潘一山,宋维源.岩石试样尺寸效应的塑性剪切应变梯度模型[J].岩土工程学报,2001,23(6):711–713.(WANG Xuebin,PAN Yishan,SONG Weiyuan.The model of plastic shear straingradient on size effect in uniaxial compression of rock specimen[J].Chinese Journal of Geotechnical Engineering,2001,23(6):711–713.(in Chinese))
    [10]尤明庆,邹友峰.关于岩石非均质性与强度尺寸效应的讨论[J].岩石力学与工程学报,2000,19(3):391–395.(YOU Mingqing,ZOUYoufeng.Discussion on heterogeneity of rock material and size effecton specimen strength[J].Chinese Journal of Rock Mechanics andEngineering,2000,19(3):391–395.(in Chinese))
    [11]李夕兵,古德生.岩石冲击动力学[M].长沙:中南大学出版社,1994:7.(LI Xibing,GU Desheng.Rock impact dynamics[M].Changsha:Central South University of Technology Press,1994:7.(inChinese))
    [12]梁昌玉,李晓,李守定,等.岩石静态和准动态加载应变率的界限值研究[J].岩石力学与工程学报,2012,31(6):1156–1161.(LIANG Changyu,LI Xiao,LI Shouding,et al.Study of strain ratesthreshold value between static loading and quasi-dynamic loading ofrock[J].Chinese Journal of Rock Mechanics and Engineering,2012,31(6):1 156–1 161.(in Chinese))
    [13]FAIRHURST C E,HUDSON J A.Draft ISRM suggested method forthe complete stress-strain curve for the intact rock in uniaxialcompression[J].International Journal of Rock Mechanics and MiningSciences,1999,36(3):276–289.
    [14]梁昌玉,李晓,王声星,等.岩石单轴压缩应力–应变特征的率相关性及能量机制试验研究[J].岩石力学与工程学报,2012,31(9):1 830–1 838.(LIANG Changyu,LI Xiao,WANG Shengxing,et al.Experimental investigations on rate-dependent stress-straincharacteristics and energy mechanism of rock under uniaxialcompression[J].Chinese Journal of Rock Mechanics and Engineering,2012,31(9):1 830–1 838.(in Chinese))
    [15]高富强,杨军,刘永茜,等.岩石准静态和动态冲击试验及尺寸效应研究[J].煤炭科学技术,2009,37(4):19–23.(GAO Fuqiang,YANG Jun,LIU Yongqian,et al.Research on rock quasi-static anddynamic impact test and size effect[J].Coal Science and Technology,2009,37(4):19–23.(in Chinese))
    [16]中华人民共和国国家标准编写组.GB/T50266—1999工程岩体试验方法标准[S].北京:中国计划出版社,1999.(The National StandardsCompilation Group of People′s Republic of China.GB/T50266—1999Standard for tests method of engineering rock mass[S].Beijing:ChinaPlanning Press,1999.(in Chinese))
    [17]American Society for Testing and Materials(ASTM).D7012—10Standard test method for compressive strength and elastic moduli ofintact rock core specimens under varying states of stress andtemperatures[S].[S.l.]:ASTM International,2010.
    [18]王学滨,潘一山,任伟杰.基于应变梯度理论的岩石试样剪切破坏失稳判据[J].岩石力学与工程学报,2003,22(5):747–750.(WANGXuebin,PAN Yishan,REN Weijie.Instability criterion of shear failurefor rock specimen based on gradient-dependent plasticity[J].ChineseJournal of Rock Mechanics and Engineering,2003,22(5):747–750.(in Chinese))
    [19]宋拴臣,张新望.煤和岩石弹性模量测定结果计算探讨[J].河北煤炭,2011,(3):55–57.(SONG Shuanchen,ZHANG Xinwang.Discussion on the calculation of elastic modulus measurement in coaland rock[J].Hebei Coal,2011,(3):55–57.(in Chinese))
    [20]翟越,马国伟,赵均海,等.花岗岩在单轴冲击压缩荷载下的动态断裂分析[J].岩土工程学报,2007,29(3):385–390.(ZHAI Yue,MA Guowei,ZHAO Junhai,et al.Dynamic failure analysis on graniteunder uniaxial impact compressive load[J].Chinese Journal ofGeotechnical Engineering,2007,29(3):385–390.(in Chinese))
    [21]尤明庆,华安增.岩石试样单轴压缩的破坏形式与承载能力的降低[J].岩石力学与工程学报,1998,17(3):292–296.(YOUMingqing,HUA Anzeng.Fracture of rock specimen and decrement ofbearing capacity in uniaxial compression[J].Chinese Journal of RockMechanics and Engineering,1998,17(3):292–296.(in Chinese))
    [22]郭志.实用岩体力学[M].北京:地震出版社,1996:21–25.(GUOZhi.Practical rock mass mechanics[M].Beijing:Earthquake Press,1996:21–25.(in Chinese))

版权所有:© 2023 中国地质图书馆 中国地质调查局地学文献中心