基于模态测试的航空管道动力学响应实验与分析

英文篇名：Dynamics Response Experiment and Analysis of Aviation Pipeline Based on Modal Test
中文刊名：中国机械工程
英文刊名：China Mechanical Engineering
作者：鲁华平 ; 贾普荣 ; 刘永寿 ; 孙波 ; 李宝辉
英文作者：Lu Huaping1 ; 2 Jia Purong1 Liu Yongshou1 Sun Bo2 Li Baohui1 1.Northwestern Polytechnical University ; Xi'an ; 710072 2.Aviation University of Air Force ; Changchun ; 130022
中文关键词：航空管道 ; 模态测试 ; 阻尼比 ; 动力学响应
英文关键词：aviation pipeline ; modal test ; damping ratio ; dynamics response
出版日期：2012-08-25
机构：西北工业大学;空军航空大学;
年：2012
期：16
出版单位：中国机械工程

摘要

航空管道是影响飞行安全的关键件之一,针对其动力学特性分析中阻尼比的影响问题,对某航空铝合金管道采用MIMO模态测试,得到其前八阶模态频率和阻尼比;对该管道施加瞬态激励,得到不同点处的时域响应数据;考虑了传感器的附加质量,计算了模态频率,分别基于恒定阻尼比和实验得到的模态阻尼比模型,分析了管道瞬态动力学响应特性,并与实测响应数据进行对比分析。结果表明:采用模态阻尼比计算得到的管道动力学响应不论是响应时间还是响应大小都更接近于实测值,对于航空管道这种安全性要求很高的结构,应尽可能采用模态阻尼比进行计算分析。
Aviation pipeline is one of the key components of aircraft;aimed at the influences of damping ratio in dynamics computation,based on MIMO modal test,a pipeline,made of aviation aluminum alloy,its first eight order modal frequencies and damping ratios were obtained.In addition,the pipeline was excited by instantaneous loads and the response data in some regions were gotten in time domain.The mode frequencies were calculated by taking into account the added mass caused by acceleration sensors.Respectively,based on constant damping ratio and modal damping ratio of testing mode,the instantaneous dynamic responses of the pipeline were analyzed and compared with test values.The results show that both of dynamics response amplitudes and the response times in calculation based on modal damping ratio are closer to test values of the aviation pipeline,it is better than that of the calculated values based on constant damping ratio.The structure with high security requirements,such as aviation pipeline,its response should be calculated based on the modal damping ratio as far as possible.

引文

[1]段志平,张亚.结构阻尼识别的方法及比较[J].福州大学学报(自然科学版),2005,33(增):208-212.
    [2]Tanrikulu A H.Application of ANN Techniques forEstimating Modal Damping of Impact-dampedFlexible Beams[J].Advances in Engineering Soft-ware,2009,40(10):986-990.
    [3]Wang R F,Yao H S,Xiong S B.Research on Large-scale Vibrating Screen Dynamic Parameters Based onTest Modal Analysis Technology[C]//Proceedingsof the 5th International Symposium on Test andMeasurement.Shenzhen,2003:763-766.
    [4]梁超锋,欧进萍.结构阻尼与材料阻尼的关系[J].地震工程与工程振动,2006,26(1):49-55.
    [5]庄新伟,淡丹辉,姚伯威.几种阻尼模型的建模方法及评价[J].中国测试技术,2006,32(2):62-65.
    [6]李田.结构时程动力分析中的阻尼取值研究[J].土木工程学报,1997,30(3):68-73.
    [7]蔡敢为,钟掘,廖道训.三维编织复合材料构件的机构模态阻尼[J].中国机械工程,2000,11(5):481-484.
    [8]冯振宙,高行山,刘永寿,等.某型飞机燃油/液压系统故障统计与分析[J].飞机工程,2007(1):50-54.
    [9]Liu Jianjun,Liaw B,Pamwar M.Dynamic Mechani-cal Properties of Fiber-metal Laminates.Crash-worthiness of Composites and Lightweight Struc-tures[C]//2001ASME International Mechanical Engineering Congress and Exposition.New York,2001:13-18.
    [10]《工程材料实用手册》编辑委员会.工程材料实用手册[M].北京:中国标准出版社,2002.
    [11]克拉夫R W,彭津J.结构动力学[M].北京:科学出版社,1981.