基于可靠度的路基均匀性评价标准

详细信息 本馆镜像全文    |  推荐本文 | | 获取馆网全文

英文篇名：Uniformity evaluation standard of subgrade based on reliability 中文刊名：交通运输工程学报 英文刊名：Journal of Traffic and Transportation Engineering 作者：李跃军 ; 吴亚中 ; 李亮 英文作者：LI Yue-jun1 ; 3 ; WU Ya-zhong2 ; LI Liang1(1.School of Civil Engineering and Architecture ; Central South University ; Changsha 410075 ; Hunan ; China ; 2.Department of Transporation of Hunan Province ; Changsha 410011 ; Hunan ; China ; 3.Hunan Communications Research Institute ; Changsha 410015 ; Hunan ; China) 中文关键词：路基工程 ; 均匀性标准 ; 有限元法 ; 可靠度 英文关键词：subgrade engineering ; uniformity standard ; finite element method ; reliability 出版日期：2010-06-15 机构：中南大学土木建筑学院;湖南省交通科学研究院;湖南省交通运输厅; 年：2010 期：03 出版单位：交通运输工程学报

摘要

提出了基于可靠度的路基均匀性评价方法,建立了路基路面结构的二维有限元模型,采用蒙特卡罗法对典型沥青路面结构在不同路基回弹模量与不同变异系数条件下的结构可靠度进行分析计算,研究了路基回弹模量变异系数对路面结构可靠度的影响,确定了评价路基均匀性的可靠度划分依据。计算结果表明:高速、一级公路可靠度临界值为95%和90%时,路基回弹模量变异系数为0.05和0.10;二级公路可靠度临界值为90%和85%时,路基回弹模量变异系数为0.05和0.15;三、四级公路可靠度临界值为85%和80%时,路基回弹模量变异系数为0.15和0.25。以计算可靠度临界值作为相应公路路基均匀性评价标准,将各级公路路基均匀性等级分为优、中、差3个级别。
A new uniformity evaluation method of subgrade was proposed based on reliability.A 2D finite element model was established to compute the reliabilities of asphalt pavements with different moduli and variation coefficients by using Monte Carlo Method.A division basis of the reliabilities was set down based on the research on the influence of the coefficients on pavement reliabilities.Computation result shows that the coefficients are 0.05 and 0.10 as the critical values of reliabilities are 95% and 90% for expressway and first class highway.The coefficients are 0.05 and 0.15 as the critical values are 90% and 85% for second class highway.The coefficients are 0.15 and 0.25 as the critical values are 85% and 80% for third and fourth class highways.Subgrade uniformities are divided into three grades when 90% and 95%,85% and 90%,80% and 85% are taken as the evaluation standards of subgrade uniformities for different highways.8 tabs,3 figs,11 refs.

引文

[1]房建果,刘树堂,毛洪录.土方路基回弹弯沉检测标准确定方法研究[J].山东大学学报:工学版,2006,36(4):52-55.FANGJian-guo,LI UShu-tang,MAO Hong-lu.Research on method of determining elastic deformation criterion for earth roadbed[J].Journal of Shandong University:EngineeringScience,2006,36(4):52-55.(in Chinese)
    [2]查旭东.PFWD快速检测路基模量研究[J].公路交通科技,2008,25(1):26-30.ZHA Xu-dong.Study of rapid test of subgrade modulus with PFWD[J].Journal of Highway and Transportation Research and Development,2008,25(1):26-30.(in Chinese)
    [3]王选仓,马玉兰,张磊.路基顶面回弹弯沉验收标准的修正[J].长安大学学报:自然科学版,2009,29(6):1-5.WANG Xuan-cang,MA Yu-lan,ZHANG Lei.Rebound deflection criterion of subgrade[J].Journal of Chang an University:Natural Science Edition,2009,29(6):1-5.(in Chinese)
    [4]张起森,查旭东.沥青路面结构的可靠度优化设计[J].中国公路学报,1996,9(4):8-16.ZHANG Qi-sen,ZHA Xu-dong.Optimization design of reli-ability of asphalt pavement structure[J].China Journal of Highway and Transport,1996,9(4):8-16.(in Chinese)
    [5]JTG E60—2008,公路路基路面现场测试规程[S].JTG E60—2008,field test methods of subgrade and pave-ment for highway engineering[S].(in Chinese)
    [6]徐旭,王祺国.基于数值模拟的沥青路面结构可靠度分析[J].公路交通科技,2008,25(5):18-22.XU Xu,WANG Qi-guo.Analysis of the reliability of asphalt pavement structure based on numerical simulation[J].Journal of Highway and Transportation Research and Development,2008,25(5):18-22.(in Chinese)
    [7]焦同战.沥青路面结构可靠性分析及其有限元模拟[D].呼和浩特:内蒙古工业大学,2007.JIAO Tong-zhan.The reliability analysis and the finite element simulation of asphalt pavement structure[D].Hohhot:Inner Mongolia University of Technology,2007.(in Chinese)
    [8]JTG D50—2006,公路沥青路面设计规范[S].JTG D50—2006,specifications for design of highway asphalt pavement[S].(in Chinese)
    [9]陈佩林,梁锡三.用蒙特卡罗法分析沥青路面结构的可靠度[J].广东公路交通,1998(1):24-27.CHEN Pei-lin,LI ANG Xi-san.Analyzing the reliability of asphalt pavement structure by usingthe Monte Carlo Method[J].Guangdong Gonglu Jiaotong,1998(1):24-27.(in Chinese)
    [10]门玉明,黄义.土层随机地震反应的动力可靠度计算[J].长安大学学报:自然科学版,2002,22(3):6-8.MEN Yu-ming,HUANG Yi.Dynamic reliability calculation for random seismic response of soil layers[J].Journal of Chang an University:Natural Science Edition,2002,22(3):6-8.(in Chinese)
    [11]GB/T50283—1999,公路工程结构可靠度设计统一标准[S].GB/T50283—1999,unified standard for reliability design of highway engineering structures[S].(in Chinese)