二次冷轧对超轻双相镁锂合金组织与性能的影响

详细信息    查看全文 | 推荐本文 |

英文篇名：Effect of double cold reduction on microstructure and properties of ultralight duplex Mg-Li alloy 作者：许晨阳 ; 石艳松 ; 兰昊天 ; 尤东阳 ; 张忱一 ; 王艳娇 英文作者：Xu Chenyang;Shi Yansong;Lan Haotian;You Dongyang;Zhang Chenyi;Wang Yanjiao;School of Mechanical Electronic and Information Engineering,China University of Mining and Technology; 关键词：LZ91镁锂合金 ; 二次冷轧 ; 显微组织 ; 力学性能 ; 断口形貌 英文关键词：LZ91 magnesium-lithium alloy;;double cold reduction;;microstructure;;mechanical properties;;fracture morphology 中文刊名：JSRC 英文刊名：Heat Treatment of Metals 机构：中国矿业大学(北京)机电与信息工程学院; 出版日期：2019-05-25 出版单位：金属热处理 年：2019 期：v.44;No.501 基金：中央高校基本科研业务费专项资金(2009QJ7);; 大学生创新创业训练计划(C201704584) 语种：中文; 页：JSRC201905036 页数：4 CN：05 ISSN：11-1860/TG 分类号：151-154

摘要

采用金相显微镜、扫描电子显微镜、硬度计、室温拉伸等手段,探究了二次冷轧对累积变形率60%、不同退火工艺处理LZ91镁锂合金板显微组织与力学性能的影响。结果表明:经过二次冷轧后,α-Mg与β-Li两相组织都沿轧制方向被压扁,出现了一定程度的取向性。其中250℃×1 h退火经二次冷轧后,细小的"扁球状"α相分布在β相晶粒周围,细小晶粒较多,力学性能也达到最好,最大抗拉强度为285 MPa左右,伸长率为34%,硬度值为73.46 HV0.025;拉伸断口可见大量分布密集的韧窝,为韧性断裂。
        Using metallographic microscopy,scanning electron microscopy,hardness tester,and room-temperature tensile test,the effect of secondary cold rolling on the microstructures and mechanical properties of LZ91 magnesium-lithium alloy sheet with 60% cumulative deformation and different annealing processes were investigated.The results show that after double cold reduction,grain refinement occurs in both phases of the two phases,and the orientation of coarser α-Mg and finer β-Li phases has appeared.Among them,after 250 ℃ × 1 h annealing and double cold reduction,fine"flat spherical"α phase distributes around the grain of β phase,the grain refinement degree is the best and the mechanical properties are the best.The maximum tensile strength is about 285 MPa,the elongation rate is 34%,and the hardness value is 73.46 HV0.025.Tensile fracture shows a large number of densely distributed dimples,which are ductile fractures.

引文

[1]孙春兰,王俊红.最轻的金属结构新材料---镁锂合金[J].世界有色金属,2017(6):1-2.
    [2]张密林,Elkin F M.镁锂超轻合金[M].北京:科学出版社,2010.
    [3]刘楚明,朱秀荣,周海涛.镁合金相图集[M].长沙:中南大学出版社,2006.
    [4]李秀军.二次冷轧技术应用研究[J].宝钢技术,2006(S1):61-63.
    [5]黄清民,魏晓伟.Mg-Li-Al合金光学金相(OM)的研究[J].轻金属,2006(3):57-59.Huang Qingming,Wei Xiaowei.Study of optical microscope of Mg-LiAl alloys[J].Light Metals,2006(3):57-59.
    [6]许晨阳,石艳松,尤东阳,等.冷轧对LAZ933超轻镁锂合金组织与性能的影响[J].轻金属,2018(10):46-49.Xu Chenyang,Shi Yansong,You Dongyang,et al.Effect of cold rolling on microstructure and properties of LAZ933 ultra light magnesium-lithium alloy[J].Light Metals,2018(10):46-49.
    [7]何宜柱,陈大宏,雷廷权,等.形变Z因子与动态再结晶晶粒尺寸间的理论模型[J].钢铁研究学报,2000,34(1):26-30.He Yizhu,Chen Dahong,Lei Tingquan,et al.Mathematical modeling of the dependence of grain size on Zener-Hollomon parameter during dynamic recrystallization[J].Journal of Iron and Steel Research,2000,34(1):26-30.