实验载荷下采煤机截割部牵引方向动态特性分析

详细信息    查看全文 | 推荐本文 |

英文篇名：Analysis of Shearer Cutting Unit Traction Direction Vibration Characteristics on Test Load 作者：毛君 ; 王恩明 ; 杨辛未 ; 陈洪月 ; 宋秋爽 英文作者：MAO Jun;WANG Enming;YANG Xinwei;CHEN Hongyue;SONG Qiushuang;School of Mechanical Engineering,Liaoning Technical University;China National Coal Association,Dynamic Research for high-end complete Integrated Coal Mining Equipment and Big Data Analysis Center;Combined Mining Technology and Equipment Engineering National Research Center;China National Coal Mining Equipment Co.,Ltd.; 关键词：采煤机 ; 截割部 ; 动态特性 ; 小波降噪 ; 综采装备力学测试 英文关键词：shearer;;cutting unit;;dynamic characteristic;;wavelet de-noising;;mechanical test of fully-mechanized mining equipment 中文刊名：JSYY 英文刊名：Machine Design & Research 机构：辽宁工程技术大学机械工程学院;煤炭工业协会高端综采成套装备动力学测试与大数据分析中心;矿山液压技术与装备国家工程研究中心;中国煤矿装备有限责任公司; 出版日期：2019-06-20 出版单位：机械设计与研究 年：2019 期：v.35;No.181 基金：国家自然科学基金资助项目(51404132);; 辽宁省教育厅创新团队资助项目(LT2013009);; 国家自然基金资助项目(51874157) 语种：中文; 页：JSYY201903044 页数：6 CN：03 ISSN：31-1382/TH 分类号：192-196+200

摘要

针对实际过程中采煤机截割部的载荷冲击大、振动剧烈的问题。综合考虑了采煤机摇臂的自身特性,以及将调高油缸的支撑特性,并依据胡克定律对其等效刚度进行了描述,建立了采煤机截割部竖直方向上三个自由度非线性动力学模型。将实验采集得到的原始数据,通过小波分解数据处理方法,对其干扰信号进行了降噪重构。以实验测试得到的滚筒截割载荷作为激励,分析了不同举升角下采煤机截割部牵引方向的动态特性。结果表明:滚筒的振动波动较大,驱动电机的振动波动较小,随着采煤机举升角的增加,截割部各部分的振动位移逐渐增大,并且振动位移的波动逐渐变大,当举升角为17°时,滚筒的振动位移均值分别为26.102 mm,最后通过实验对模型结果进行了验证。
        According to the problem of larger load impact and violent vibration of shearer cutting unit in the actual process.The self characteristics of the rocker arm of the shearer and the supporting characteristics of adjusting high cylinder were taken into consideration.The equivalent stiffness was described based on Hooke's law.A nonlinear dynamic model of 3 degrees of freedom in the vertical direction of shearer cutting unit was established.The original data obtained by the experiment were de-noising and reconstructed by the wavelet decomposition data processing method.The cutting load of the drum obtained by the experiment test was used as excitation,the traction direction dynamic characteristics of shearer cutting unit under different lifting angles were analyzed.The results show that the vibration of drum fluctuates greatly.But the vibration fluctuation of the rocker arm and drving motor is small.With the increase of the lifting angle of shearer,the vibration displacement of cutting unit gradually increasing,and the fluctuation of vibration displacement slows down bit by bit.When the lift angle is 37 degrees,the average values of vibration displacement of drum is 26.102 mm respectively.Finally,the results of the model are verified by the experiment.

引文

[ 1 ] 刘送永.采煤机滚筒截割性能及截割系统动力学研究[D].徐州:中国矿业大学,2009.
    [ 2 ] 刘建功,吴淼.中国现代采煤机械[M].北京:煤炭工业出版社,2011.
    [ 3 ] SHU K,WATARU H,TATSUO S,et al.The non-linear pheonomena in vibration cutting system the establishment of dynamic model[J].International Journal of Non-Linear Mechanics,2002,37:541-564.
    [ 4 ] 毛君,刘晓宁,陈洪月,等.采煤机截割部传动系统刚柔耦合动力学仿真分析[J].机械强度,2017,39(5):1138-1144.
    [ 5 ] 赵丽娟,田震.薄煤层采煤机振动特性研究[J].振动与冲击,2015,34(1):195-199.
    [ 6 ] 武健康,王义亮,杨兆建.采煤机整机动力学研究及行走轮受力分析[J].太原理工大学学报,2017,48(5):783-787.
    [ 7 ] 谢苗,闫江龙,毛君,等.采煤机截割部振动特性分析[J].机械强度,2017,39(2):254-260.
    [ 8 ] 陈洪月,刘烈北,毛君,等.激励与滚筒振动耦合下采煤机动力学特性分析[J].工程设计学报,2016,23(3):228-234.
    [ 9 ] 陈洪月,白杨溪,毛君,等.多激励下采煤机在行走平面内的非线性振动特性分析[J].机械设计与研究,2016,32(2):166-170.
    [10] 陈洪月,白杨溪,毛君,等.工况激励下采煤机7自由度非线性振动分析[J].机械强度,2017,39(1):01-06.
    [11] 刘长钊,秦大同,廖映华.采煤机截割部机电传动系统动力学特性分析[J].机械工程学报,2016,52(7):14-22.
    [12] 朱卫波,杨兆建,王义亮.采煤机截割部行星齿轮动力学仿真[J].煤炭科学技术,2010,38(5):80-82.
    [13] 杨义勇,金德闻.机械系统动力学[M].北京:清华大学出版社,2009.
    [14] 张天赐,庞新宇,杨兆建.自适应小波阈值融合去噪法对采煤机振动信号的处理[J].太原理工大学学报,2017,47(8):170-173.
    [15] 刘春生.滚筒式采煤机理论设计基础[M].徐州:中国矿业大学出版社,2003.
    [16] E 3.采煤机破煤理论[M].王庆康,门迎春,译.北京:煤炭工业出版社,1992.